paint for masks

[Dskize]

yeh, but they are..

 

[Ahdinko]

I dont rate the Krylon.

Used some of it on my Dye Invisions, it stuck to the grills of it just fine, but on the flexy bits, it cracked and peeled before i even got my goggles back together.

 

[balf]

did you clear coat it afterwards or just leave it unfinished

 

[Ahdinko]

Used some Plasti-Kote Clear Super over the top.

 

[big kid]

i was wondering if anything would stick well to the rubber parts aswell but sod it ill give it a go

cheers guys

dan

You two are fags.

I would use Krylon Fusion paint.

oh and if thats you orlando stay off my threads your a bell end.

who cares if there fags atleast they are helpfull ones lol

 

[Big Mac]

Used some Plasti-Kote Clear Super over the top.

how many layers of each though?

 

[J@mes]

how many layers of each though?

lots of thin layers, maybe 10-15 thin layers, then a good 5 thin layers of clear is best.

if you put 3 thick layers on, its gonna crack with out doubt

-james

 

[Big Mac]

lots of thin layers, maybe 10-15 thin layers, then a good 5 thin layers of clear is best.

if you put 3 thick layers on, its gonna crack with out doubt

-james

thats what i was getting at - how many layers did he put on and how long inbetween each one etc etc etc

 

[Ahdinko]

I used some plasti-kote white primer as a base layer, done about 6 or so layers of that, real thin ones too. This said 45 mins between each layer, so I left it at least an hour between each one anyway.
Over the top of that i done about 5 layers of Krylon, again thinly
This was about 2 and a half hours between each layer
Over that I think i done 3-4 layers of Plasti-kote, a little bit thicker.
About 4 hours after each layer.

 

[J@mes]

I used some plasti-kote white primer as a base layer, done about 6 or so layers of that, real thin ones too.
Over the top of that i done about 5 layers of Krylon, again thinly
Over that I think i done 3-4 layers of Plasti-kote, a little bit thicker.

how long where you leaving for each layer to dry?

-james