Occasional Low Shot--Eblade

[pb-afroman]

Occasionally, there will be a low shot on my cocker when I am shooting fast. I was using a halo when this happened, so I think that maybe it could have been double feeding, but I haven't had a chance to try it with another hopper since so I'm not sure. What could cause this to happen, and what will fix it??

 

[jahlad]

could be that you are fireing fast enough to starve the valve chamber of air...eather your inline reg or primary reg might not be recharging fast enough or your valve chamber could be small or even your valve might be the prob.

what are you using for the following
1)primary reg
2)inline
3)valve
4)year of cocker and is it a mini or standard length

i might be able to point you in the right direction of a fix

or as you said it could be the halo double feeding in which case you need to check your adb.....what sort is it and is it set correctly

 

[pb-afroman]

The front reg is a brand new palmer micro rock, the inline is a sidewinder, it has the stock wgp valve and its a full length body.

 

[pb-afroman]

I was just thinking about this, and I thought it might be important to add that there wasn't really an in-between. The shots were either normal or low; they didn't seem to either ramp up or down while I was shooting.

 

[Skeet]

whas your output preasuure from your air source.....also might be an ide to get a supercharger valve in it...

 

[Gurney]

Sounds like what my teamate had.......
When he ripped a string out one ball outta every 20 or so would just drop off.
He rang planet and they said to try another Inline on it and if it did`nt do it after that then the inline is shagged..........
So if you know somebody else with a cocker nab their inline

 

[Skeet]

Yeah...was gonna say that those regs arent all that great for an eblade due to the recharge time...they are pretty old now...try a Black magic...but obviously prove that the inline is the fault first...

 

[pb-afroman]

I have the stock WGP reg still...I suppose I can try that out. Also, I'm using a PMI preset to 850.

 

[Skeet]

you only want about 550 600 psi going into the inline

 

[TOOLE]

the stock reg should be fine, the only difference between them and the black magic is that the black magic is externally adjustable & better looking!