AutoCocker....

[Skeet]

middle barb, goes to lpr.
Furthest one, goes to front of ram, other one goes to teh back, nless you have a hinge frame, in which case its teh other way round, also depending oin teh three way, in which case, its teh other way round.

Timing is in teh COCKER TIMING AND TROUBLE shooting thread..or...this is all you ever need to know.

http://www.moodypaintball.com/pages/tech/eblade.htm

 

[Quicktime]

or go on to cocker tech and watch the guy's video which i i did last night at one in the morning. and timed it. thanks alot skeet. your also savior. <3

 

[Quicktime]

just to make sure skeet, in the end i never got any locktite, there was evidence that it has been put on the QEV's before hand and i should have probably put some on the LPR barb when i put it back in. Would you say it would still be ok to use with out Loctite? dont want any of my parts flying off. The barb on the LPR i replaced with a barb from my 3 way, which have more thread on it and managed to stay in the LPR pretty tight (i couldnt unskrew it with my hands - i'd need a wrench) Is this ok? i dont want it flying out like a bullet.

 

[Quicktime]

Whats the best way to get hoses on barbs also?

 

[Skeet]

Push the hoses on...you could warm the hose slightly, but they do push on.

If it leaks, it needs loctite..It wont fly out as its only running around 60psi.

Could probably do with it on teh qev's but if necssary, use ptfe tape.