any 'cocker tech's/enthusiasts

[desponge]

so anything 6-32 is ok ?.....or call planet.....

 

[Canon Fodder]

Bung me your address by PM, I've got some hanging about some where, I'll send you a couple.

 

[Gee Tee]

so anything 6-32 is ok ?.....or call planet.....

Yes 6-32 unc but extra short

The 1/8" length mentioned above by Gadget is probably about right

 

[Canon Fodder]

Yes 6-32 unc but extra short

The 1/8" length mentioned above by Gadget is probably about right

1/8" length are the ones I've got from model fixings and they seem to work, had to buy 5 when I bought them, hence a couple of spares left over.

 

[desponge]

see....if I didn't ask, I wouldn't have known f**k all about this

got to love the paintball community

 

[Gee Tee]

Some of us have been shooting, tuning, building and customising autocockers in various forms since the early 90's. So you have over twenty years experience to make use of here if needed. Cockers are seen as a bit of a dark art, but they are actually pretty easy to tech once to get used to them. The Eblades are even easier to fettle, because most of timing cycle is controlled by the electonics in the grip frame.

 

[Evil Rich]

This should be a sticky or Cocker bolt/screw/barb referencing

 

[Evil Rich]

Yep the coupler rod locking screws are 6-32 UNC as I suspected. If you got overlength ones you can always shorten them by hand with a small grinder/dremel. But it is a pain in the arse to do because they are difficult to hold. You need to get them the right length or they can foul the 3 way or main body, which will cause rod to catch and balls up the timing.

3way or 5way solenoid cover- 15/32"-32
Barrel- 15/16"-20 Oversize GH-7
Banjo Bolts- 1999 and earlier: 3/8"-24; 9/16"-24 in 2000 and newer; 3/4"-20 for merlin
Cocking rod- 10-32 on both ends
Detent- 3/8"-24
Eblade trigger stop set screws- 6-32
Ebade eye cover secrew- 4-40
Frame mount screws- 10-32
FRM Screw- 1/4''-28 UNF w/ a 1/4" 12point star socket head
Hammer (Nylon Setscrews)- 10-32
IVG- 3/4"-16
Lug- 1/4"-28 x 1/2 inch long
LPR- 1/8"-27 NPT
LPR Barbs- 10-32
Ram Barbs- 10-32 and 6-32
Ram Shaft- 6-32
PumpArm- 10-32
Timing rod coupler set screws - 6-32
Valve locking nut- 5/16"-24 1/4inch long setscrew
Valve jam nut- 5/8"-18 5/16" hollow lock screw

So what size are grip screws on an Eblade and the beavertail bolt

 

[Canon Fodder]

I've just put them in the post, careful with the little plastic bag in the envelope, found out there was a hole in it when I was flicking it to settle the screws into one corner, took a while on hands and kneesa to find it again!

 

[Gee Tee]

So what size are grip screws on an Eblade and the beavertail bolt

The beavertail is normally 10-32 as are the main gripframe to body mounting screws

Grip panel screws are 6-32