2k2 Timmy - can't get above 180fps - HELP!

[Stan]

Bought this timmy: http://www.p8ntballer-forums.com/vb/showthread.php?t=58740

and can't get it to shoot over 180fps. Can someone give me a real basic guide to what i'm missing? This is my first Timmy and i don't want to **** it up.

So far i have:

Adjusted the vert reg to 85-100psi on the gauge.
Adjusted the horizontal reg (under barrel).
Adjusting the dwell doesn't make a huge difference.

Is this right? What am i missing?

 

[markhamgreg]

Have to tried cleaning and greasing all the regs, cup seal etc.

 

[beasty1711]

timmys do respond well to regular servicing of both regs.. i tend to find that i get noticable volocity drops towards the end of the days play so as markhamgreg suggests... lots of lube..

another thing that i find sometimes makes a difference is worn detents.. these are fairly cheap and tend to wear fairly quickly

 

[Stan]

Have stripped, cleaned and relubed the regs.

What's the highest pressure i could go to on the gauge (by winding up the vert reg) before i risked blowing the 'noid?

 

[beasty1711]

i cant remeber the value of the top of my head.. but when i over loaded it just popped one of the hose's off.. so it was simply a case of turn it down again and poping the hose back on

 

[Stan]

Not quite prepared to take that risk but thanks!

 

[NitroBall]

plenty of info and settings here m8
http://www.intimidatorowners.com/forums/index.php?

 

[Stan]

Thanks for that... couldn't find anything particularly easily on there though!

 

[markhamgreg]

set the lpr at a max of around 100 psi. do this by adjusting the reg below the barrel then adjust the vertical reg to adjust the velocity.

 

[markhamgreg]

http://www.ottersccustoms.com/pdf/intmanual02.pdf

Manual hope it helps