Shocktech drive cone problem!

[Ninja]

hi guys

was just wandering if any one had fitted a shocktech drive cone to a reloader B2.i've got one and for the life of me cant make it fit. The spring housing seems to be to long so that the drive cone does'nt sit far enough down for it to catch the spring, so you cant tension the cone!

I'm thinking about sanding it down but want to see first if anyone has had similar probs and if there is an easy solution!

cheers for any help

 

[Lovetone]

if its any help...

yes i have tried to fit one

yes it was a hassle like that

no i cant remember how it was sorted in the end doh!

but it got sorted with no modifications.
I wouldnt buy one myself, hassle, plus its metal = heavy = slower loader

 

[Ninja]

funny thing is i've tried fitting it to my halo and that's cool other then when you tighten the center screw up it locks the cone solid only got one as my plastic one broke!

 

[Lovetone]

trying to wrack my brains i think i took some plastic spacer off the centre of *something*...might be the drive cone itself. check for any extra that you dont think you need.

 

[Oily]

I've fitted one to my Reloader B and i've had no fitment issues

Sounds like the screw is to short or the thread is cut differently on the shaft(Reloader B to deep,Halo is ok) and its bottoming out on the cone not the shaft

 

[Lump]

the problem is in the cup, you have to cut off a small amount on the ridge inside the cup

 

[Ninja]

lump is that on the b2 your talking about? also do you mean the internal ridge that goes over the rip drive spindle?

 

[Lump]

is it rubbing againt the race way ?

 

[Ninja]

is it rubbing againt the race way ?

depends which loader your talking about mate, on the b2 the tab underneath the cone does'nt reach the top of the spring to be able to load the spring!

 

[Lump]

yep same problem. i think i found a shorter cup. there are two height of cups and this is why it wont fit correctly

ps what board is in the ton ton ?