PM6: Rattling Frame?

[lemonadeX]

Ok, thanks guys I'll give the Poofter tape a try

-Will

 

[Fly]

Before you tighten them both up push the grip frame towards the front reg, this will close up the gap and give you less 'wobble'

 

[lemonadeX]

Thanks for the tips guys. I went with lump and Fly's suggestions of PTFE-taping the screw and ensuring the frame is pushed up against the Hyper2. At first it seems secure, but then after a little use it's back to its wobbling ways

Is this likely to be a problem with the actual screws, the frame or the body? Open to any other ideas, although in this situation I'd like to steer clear of loctite.

Cheers,

-Will

 

[Lump]

weld it on

 

[Fly]

weld it on

Sounds like a plan

New screws on the way Will

 

[lemonadeX]

Thanks Neil You reckon they could be the cause? Look as though they've been screwed in/out a fair amount, anyway.

-Will

 

[Lump]

Thanks Neil You Look as though youve been screwed in/out a fair amount, anyway.

-Will

lol

 

[Fly]

Could be mate, do they look worn? I'll send you some slighty longer ones as well.

 

[lemonadeX]

The actual thread of the front frame screw looks in good nick. The head has various nicks and dents, but of course that won't cause the rattling.

What does seem a little disconcerting is that as I'm tightening the allen key in the hole (go on lump, make another innuendo out of that ) it comes to a reasonably abrupt stop, instead of becoming progressively resistant.

-Will

 

[Mario]

New screws.

Your threads are worn.