Halo Problems :(

[Silver-0]

Hi Guys
My reloader wont turn on just put new batteries in it, and nothing I've tried will get it to turn on. any suggestions?

The last time it works was at our last training sessions and at the end of the evening to locked up and the light was flashing green and red which i figured was low battery but now having no luck
anyone got some suggestions?

 

[lemonadeX]

Green/red flash means there is a jam of some kind (it is on Halo's, anyway). If it isn't turning on at all, take it apart and make sure the battery->board connection is OK. The wire may have been pinched or the connector detached from the board so check those first.

-Will

 

[Silver-0]

Good plan thanks for that. lets see what this sucker looks like on the inside

Green/red flash means there is a jam of some kind (it is on Halo's, anyway). If it isn't turning on at all, take it apart and make sure the battery->board connection is OK. The wire may have been pinched or the connector detached from the board so check those first.

-Will

 

[Bob]

Also check that the on button is okay, it is possible to break em, especialy if your sujing suicide shells.

 

[bulgy-snatch]

try cleaning the eyes

 

[Silver-0]

didn't know my Halo had eyes? is that what the white wire goes to?
but its working now thank goodness and all I did was open it up and it work. but this has happened before and it struggles to turn on if there is paint already in it.

 

[darren maskell]

Your not rearly suppose to turn them on with paint in or thats what i got told as it spins on start up and may smash the paint thats already in the feed neck.

 

[zipatronic]

Your not rearly suppose to turn them on with paint in or thats what i got told as it spins on start up and may smash the paint thats already in the feed neck.

just tried turning mine on with my finger in the feed neck and it did spin up but less than 1/4 of a revolution, sometimes doesnt even move when switched on.

 

[Silver-0]

yeh mine wont even turn on at all with paint in it, let alone turn slightly

 

[zipatronic]

you could all ways try tipping it upside down when turning it on if its got paint in it to see if thats helps?

your not over filling it are you? needs space to turn to get balls into feed neck.