Shortening hopper feed tube?

[webber]

Looking to shorten my hopper feed tube. is there a certain way to go about doing this. i own a Halo B.
Any advice?

thanks
Webber

 

[RainbowShooter]

use tape to mark off where you want to cut, its how I would do it

 

[J@mes]

well i did this to my vlocity, with out any problems... but im not sure about Halo's.

all i used was a hacksaw and a steady hand.

-james

 

[webber]

end up a neat job?

 

[RainbowShooter]

in other words webber dont use a chainsaw, use a fine bladed saw of some sort

 

[webber]

lol i gathered that buddy

 

[no-infernomark]

dont u have to worry about where the balls line for the eyes to function? i.e in .68 intervals. so if you was to remove it do it in multiplies of .68 just a thought

 

[jamtheman188]

dont u have to worry about where the balls line for the eyes to function? i.e in .68 intervals. so if you was to remove it do it in multiplies of .68 just a thought

I dont think so, as when you get low rise or high rise feednecks they arnt the size of a paintball in difference of hight.
If you know what i mean, i may have worded that a bit rubbish.

 

[no-infernomark]

yeah i know what you mean, but its worth looking at where the ball stops in the hopper, as the eyes do tend to not see half of half the ball haha

 

[J@mes]

it doesnt matter if you dont cut it in multiples of .68 least it didnt matter for my vlocity, which works on eyes aswell.

just take you time with a hacksaw ( the little kiddy type ones), and make sure you cut it flat.

-james