Vlocity speed changing?
- Thread starter Ironkid
- Start date
...and then press the little button the number of times you want. The rate starts at 1 (least force) up to 8 i believe. The more force, the more likely paint is to break under the strain and so 8 is only recommended for pretty hard paint. When you turn off the hopper and then back on again and press/hold the button the LED will flash the number of times you've pressed.
you dont keep pressing the botton, you hold it down, it cycles thro the settings, just let go when you get to the setting you want.
-james
-james
How do you suggest you change the force then? By pressing the button....
I did this the other weekend after reading the manual.
You need to press it the number of times, between 1 and 8, to set the force. Holding it down will just be a 1.
oddjob, you hold down the button till it flashes then you select the force by holding it down till you let go...
as far as im aware you dont press it
as far as im aware you dont press it
you hold it down, you dont keep pressing it.
hold it down (and say you have it set to 3 and want it set to 8)
it will flash 3 times,
then it will flash 4 times,
then it will flash 5 times,
then it will flash 6 times,
then it will flash 7 times,
then it will flash 8 times, and now let go of the button, turn it off, turn it back on, then press the button, and it will flash 8 times.
-james
hold it down (and say you have it set to 3 and want it set to 8)
it will flash 3 times,
then it will flash 4 times,
then it will flash 5 times,
then it will flash 6 times,
then it will flash 7 times,
then it will flash 8 times, and now let go of the button, turn it off, turn it back on, then press the button, and it will flash 8 times.
-james
You hold the little button down and this will cycle it through the force modes. The force mode will correspond to the amount of orange flashes the LED gives. 1 being the least force 8 being the most. You just let go on the setting you want and it saves that setting it is now safe to turn off.