Bottle/Marker problem?

[PBWill]

Hi all, i was recently given an ETek Ego ( as ive posted before ) and today when i went outsire to fire it...the air wouldnt go through it!! heres what happens, but im pretty convinced it down to the pressure in the tank:
screw in the bottle, then turn the air on by the little knob/screw thingy at the end. the air goes through, i can hear it. then i turn on my gun, set it to ramp eyes off and start pulling the trigger. i know the gun works becuase i can hear the little electronic click as i pul the trigger, and when it ramps. i dont know if its down to this, the tank gauge is on 1500, which im going to assume is when it starts going downhill and needs to be filled up? anyone shed some light on this?


Will

 

[sx1990]

It will still fire even if you had 1500 psi in the bottle, when you screw the tank in does the bolt ping back? If it is getting air depending on where te bolts start position is it should spring back or have tension on it so it can not move. If it doesn't you may need to look into dismantling the asa (little knob thing)

 

[PBWill]

No, it doesnt ping back, im not sure what to do? any solution to this?

Will

 

[Mclovin101]

or the reg is all the way in ( Off) so no air is getting through that way

 

[MeDiC]

Or the LPR is adjusted too low and not cycling the rammer...

 

[PBWill]

i dont know if i could have done any of the above by acciendt, i was shooting it the day before with no problems!

Will

 

[Jezz]

Check the pin hasn't fallen out of the OOPS knob bit, nearly lost mine once.

 

[PBWill]

How can i check that?

Will

 

[frenchy2475]

If the gun was firing the day before and you have not touched or adjusted anything then it should work now. Have you tried a fresh good quality battery?

 

[PBWill]

I'll try it. I dont know if it'll work because the battery in there does what its supposed to do, but i'll do it anyway

Will