where can i find board diagrams...

[ChiZZerS]

for 2002 shockers...
i need good ones which tells me what things do and what not to do ect
help will be good

 

[John C]

Schematics or circuit diagrams?

Short answer: Nowhere

 

[ChiZZerS]

well ile jsu t get to the point then....
i opend my shocker for the 1st time today...
and on the board there is 2 small boxes...
on each box there is 4 tiny switches...
what will happen is i mess around with them?

 

[Philip]

You will mess with the timing on board, meaning misfires, chops, even worse efficientcy....or you could improve the marker.

 

[L J]

generally they would be something to do with timing, ie valve open and close time, dont mess with them

 

[ChiZZerS]

well i am getting loads of chops and misfires...
so dose anyone know where i can find out what the combonations should look like?

 

[Skyhawk]

Chops?... sounds like a shocker to me



Skyhawk

 

[ChiZZerS]

NOT LIKE THIS

Dark Worrior ( eric ) has seen what its like!

chop, chop, chop, fires 2 balls?, chop, waits a sceond to gas up again, fires 1 ball, chop, fires 3 balls!, cho, regases again...

it relly bad!

 

[Philip]

Try a few other things first, like cleaning/lubing the piston, the bolt and stem and the poppet.

Then check the co2 passage for blockages or dirt. Follow that up by cleaning the inside of the body, all o-rings and the platic spacers.

 

[ChiZZerS]

i wanna play around with these switches!....

but i am afraid that it might go wrong!....

will it fry my board or 'noids, if i flicked them?