Just occurred to me mate, have you adjusted the trigger? If so try adjusting it back a little cause if adjusted to much the micro switch is permanently depressed.
Vanguard Creed
- Thread starter bojjob
- Start date
look at the trigger mate, there should be 4 screws, loosen all them off a lot, then see if it work, if it does fine tune the trigger.
I'm in the south east, but unfortunately, i'm pretty rubbish with creeds, i had problems recently, and just sent it off to martin at vanguard, he's a great guy!
Have a go at a few things your self, if no luck, send it off, where is the leak?
I'm in the south east, but unfortunately, i'm pretty rubbish with creeds, i had problems recently, and just sent it off to martin at vanguard, he's a great guy!
Have a go at a few things your self, if no luck, send it off, where is the leak?
Could be the issue
This would be the screw you would need to adjust for the microswitch if thats the issue
Ill try it now, should there defo be a solenoid clicking with all screws fully out and eyes off? And the leak sounds around the bottom macroline fitting area
YES, I HEAR CLICKING <3 You cannot begin to comprehend the joy rushing through me right now Thanks guys, now to just sort out that lil leak, but as long as it fires fine in an aired up test tomorrow, I can deal with a tiny leak. Again, I literally cannot thank you guys enough
Thanks guys, now to just sort out that lil leak, but as long as it fires fine in an aired up test tomorrow, I can deal with a tiny leak. Again, I literally cannot thank you guys enough
Good goodYES, I HEAR CLICKING <3 You cannot begin to comprehend the joy rushing through me right now
When i air mine up it leaks and i wiggle the Macroline and it seals it self. You might just need a new bit of macroline.