Unscrewing 08 Barrel

[dicksin200]

ok

so your turning it the right way ok so heat it up (but first get a tub of cold water) heat up the barrel when hot get good grip on it and put in the cold water and turn.if this dont work as it normally does.then get some wd40as it has a tube on it spray directly inside the joint not on the out side as the seal will just stop it getting in then roll it round for 2-3 mins and leave for an hour or so keep checking it as it may loosen stright away is it the one i sold you m8 ...ok once undone tiny bit of grease on it will stop this happening again not loads

 

[Echowitch]

Cheers, I'll try when I get home. (Currently at Net Cafe as no broadband for another week......grrrr slow flaming Sky)

If all else fails I might give the guys and girls at Planet a ring and see if I can send it to them. (I presume they have vices and stuff for gripping and turning.)