Tippmann TiPX 1x mag 1x zetamag

[Jimmmmy]

Hi Alex,

You seem to have posted the following on UKS:

http://www.ukscenario.com/forum/viewtopic.php?f=71&t=37820

I'm a little unsure why you haven't mentioned the leak here?

"Also, the gun leaks some co2 into the gun but this can be fixed by replacing an oring in the co2 compartment or tightening the bolt onthe removable lid(doesn't effect shooting)"

 

[Alex H]

Hi Alex,

You seem to have posted the following on UKS:

http://www.ukscenario.com/forum/viewtopic.php?f=71&t=37820

I'm a little unsure why you haven't mentioned the leak here?

"Also, the gun leaks some co2 into the gun but this can be fixed by replacing an oring in the co2 compartment or tightening the bolt onthe removable lid(doesn't effect shooting)"

i can swear i wrote it here because i just copied the thread over, might have accidentally deleted it, thanks for spotting

 

[Jimmmmy]

No problem bud, just wanted to try to help save any potential headache

 

[fintan harding]

i can swear i wrote it here because i just copied the thread over, might have accidentally deleted it, thanks for spotting

does it reduce the efficiency/amount of shots in any way at all........

and also does it come with those 14 sparklets you mension on there

 

[Alex H]

does it reduce the efficiency/amount of shots in any way atall

Well, some co2 cartridges work fine and some don't, the ones that dont' do reduce the amount of shots,if you upgrade to HPA it'll be fine, Have been told to either tighten the bolt/screw up on the removable lid or replace o ring and it'll sort it, i normally get 2 mags out of 1 co2

 

[fintan harding]

Well, some co2 cartridges work fine and some don't, the ones that dont' do reduce the amount of shots,if you upgrade to HPA it'll be fine, Have been told to either tighten the bolt/screw up on the removable lid or replace o ring and it'll sort it, i normally get 2 mags out of 1 co2

i have no experince in pistols and would have no clue what to do so unless you could sort out the problem i will have to leave it for now

 

[Alex H]

i have no experince in pistols and would have no clue what to do so unless you could sort out the problem i will have to leave it for now

I will tighten it up now, are you looking to run co2 on it or hpa?

 

[fintan harding]

co2 mate

 

[Alex H]

co2 mate

Just tightened and tested, no leaks atm but will test again when it's sold, with the small co2 cartridges the FPS will drop when the co2 is running out

 

[fintan harding]

so aslong as there is no leaks at all now,pm me your paypal email