Speed Help needed please...

[Ben Frain]

1. Degass marker
2. Add large volumiser
3. Wind up your max flow to just over 200
4. Adjust marker via foregrip/reg so it's shooting 295fps

If FPS is too low increase input pressure from max flow in 25psi increments (fire a few shots to stabalise pressure after each psi boost before measuring on chrono) or up dwell one notch at a time until you get constant 290 fps range

Job done.

 

[Hudson']

his max flow is hp so he wont be able to get it to 200 so its gonna need to be adjusted by the reg.

 

[liamliddy]

does that mean i wont be bale to put it down to 200 on the maxxy?i havnt got it with me so cant remember what the dial goes down to?it is hp though, please help, and benfrain, cheers for the detailed info

 

[Ben Frain]

Liam, I'm not sure how low the high pressure max flow goes, I've never used one. No doubt someone with more knowledge of maxi's will know for sure. From what Com has said about it not going down to 200psi, there is little point adding the volumiser if the high pressure maxi's don't run that low, as that is the real benefit of adding the volumisers - having less pressure running into the marker...

 

[Collier]

I think the HP maxy runs best above 200!

Best thing to do is try it!!

Paul

 

[Tom Allen]

volumiser

I'm not sure if this will help.

Your maxflo being hp, is just a substitute for the angel air so set this to the normal pressure (around 700 psi) Then with your volumiser on adjust the min reg to obtain the correct fps.

The volumiser lowers the working pressure of the gun, but if you have to increase the dwell to get the required fps there is a trade off there. Lower working pressure but longer on time and therefore less cycles per second.

Tell me if this sounds wrong, but thats how i see it.