smart part eos trouble!

[Lump]

have you got the HP up enough ? how you would change the velocity ?

 

[Rider]

200psi may be high enough - depends on the insert used.

 

[Gidge007]

i just use the green insert, and i change the velocity by puttin an alan wrench up the regulator

 

[balf]

Listen to Rider, he knows his shizzle, if I had an ION style gat I'd send it to him for fixing (mainly because I hate working on ION's but it's not the point) For EOS with ny insert psi should be 220+

 

[Rider]

if you want to send it to me i'll have a look.....no charge - just pay the postage.

and balf - mine runs flawlessly on 200psi with green insert - never understood why , it shouldn't - it just does... unless the side gauge is knacked - which is highly probable...

 

[balf]

Or your running an abnormally high dwell, but having said that, my shocker did (no board in atm) run at 165psi at 9ms dwell, which it shouldn't either

 

[Rider]

no, dwell is only 5 or so clicks above a full strength cycle.

 

[balf]

the general rule is low op. pressure high dwell, low dwell high op. pressure.

The only way you will know is by effiency figures, if ity seems to be inefficient thats your reason, but you may just be special, like me.....and not the little yellow bus special either.

 

[Rider]

runs at 16 clicks = 8 + (.5x12) = 14ms dwell

seems consistant over the chrono (+/- 3ish fps), virtually no drop off, and i'm happy with the efficiency.

 

[Gidge007]

you dont think the problem would be anything to do with the board in the gun or is it just something to do with the parts the air goes through