Shocker board query ..

[MINTY_71]

Don't think that will help now mate .. Don't think it's the board that causing the air to leak out the front and cause it not to
Fire..

Has anyone got knowledge of shockers. And who would be willing to take a look at it.
Would really like this gun back up and running .
Something I have done has caused this issue ..
As it worked before ..
Need help .. Here.
Thanks...

 

[Narkadox]

Did you mess around with the Dwell settings? If you've lowered your dwell too much, the gun will try and cycle but wont be able to fully and sometimes there's enough air to move the bolt forward but not enough to get it back again so it stays stuck open with air leaking. Try pushing the bolt back with your finger and see if this stops the leak. If it was all working fine before and has only been playing up since you started tweaking the board, chances are you've gone wrong somewhere.

Kind of hard to accuratly diagnose without knowing exactly what you've done, but it sounds like your dwell is too low to me.

Here's a guide to the Shocker Setings. http://www.zdspb.com/tech/mguide/shockersft/adj_electronics.html

 

[MINTY_71]

Dwell is set at about 30 chirps from the lowest setting .

Also when I put the blackheart board back in to give a factory reset .. It didn't. I held on down on tigger and went to turn gun on. It chirps once but the led didn't flicker and guns power button didn't even light up . ???.

 

[MINTY_71]

Nightmare continues...

I've just tried to take apart the trigger frame from the rest of the gun
But one of the Allen screws is sheard off so can't get it out..

All I have now is an expencive paper weight..
Bloody shame.. Didn't even get to use it ..
Only bout it about 4 weeks ago...

 

[MINTY_71]

Wanted to check the solenoid .. But can't get the gun apart..

 

[cheyenne]

hi m8 if you send it to me ill sort it out

 

[MINTY_71]

Oh thank you so much.. Your a life saver.. If you pm your address I will send it off As soon as , by special delivery ..
I've put the original standard board back in. But can send it with the black heart board to you may need it.

I really appreciate this .. Thank you so much.
I will pay you for your time ..

Regards .... Neil .

 

[PKR WOODY]

If you still don't have any joy with the marker there is a smart parts place in Kent that might be able to help you out. If you need the numbers just ask mate.

 

[MINTY_71]

Thanks mate.. Hopefully Cheyenne can fix it.. But will contact them if all else fails ..