Pump gun pictures

[Gee Tee]

PTP - FX pump thread on custom cockers forum. Not sure if all the buyers got sorted in the end because the thread died about a year ago

The problems kick off at page 13

http://customcockers.com/forum/showthread.php?44242-URGENT!-FX-Cocker-Pump-Body-Kit

 

[Gee Tee]

double post

 

[TrustMe]

It was a limited run with numbers mine happen to be #8. Quality control was out the window there where issues with the first version (V1) mainly the body rest was minor, bodies were return for a replacement. The rest of the information is in linked Gee Tee provided.

 

[Zondo]

It was a limited run with numbers mine happen to be #8. Quality control was out the window there where issues with the first version (V1) mainly the body rest was minor, bodies were return for a replacement. The rest of the information is in linked Gee Tee provided.

I was wondering what happened with all that. At least you guys on the Sniper buy got new bodies... I was curious how that was going to go after the MM2K9.

 

[TrustMe]

Will never purchase from them again, we had to send V1 body back at our cost btw, should have done more research before jumping on pre-order stuff. V2 is all good to go, not sure about MM2K9.

 

[swe_crazy]

 

[Gee Tee]

Finally got round to fitting the XMT minimag body to pump after Renie annodised it grey

Was aiming for the matt stainless effect of the classic mags

 

[Gee Tee]

Rebuilt my WGP sniper that I've owned from new since 1989 - Serial #5059. Seen loads of modifications in it's evolution, and even ran it as an autococker for a while. I've removed the sight rail and rounded the body corners by hand. Fitted a Y2k hammer, valve, bolt and back block, Belsales angry 45 frame, CCM lightweight pump kit, MacDev gladiator inline reg, and Eclipse OOPS. Was getting 280 +/- 3 fps on chronograph test Sunday. I think the 0.681" Lapco 'TightStick' barrel from PumpPB.com helped

Thanks owed to Renie at VIP for the fresh dust black annodise finish

 

[TrustMe]

Well done Gee Tee, nice flow through out. ^^^

 

[Gee Tee]

Thanks. I've had a few say it looks like an early CCM, which is a nice compliment

Want to swap the front ASA for a pump version minus the 3 way hole - lost the original one