Pulse Speed Feed Help

[Polly]

cut the fingers down so they aint so long, so they just tuck under the rim, and loosen them up by bending them for a while

 

[Seany]

try not too rush just take your time and if possible pop behind your bunker for 2 seconds so you can pot up nice and safely if needs be hold your pot steady and give it a good few shakes, the 'ghetto' speed feeds are top notch though

 

[rich666]

Guys,

When playing sup' air I find that I seem to get shot out when reloading, and in an effort to make the process of reloading quicker and easier got a speed feed and fitted it to my pulse.

Trouble is when I try and load the bloody paint won't feed in properly and when it gets to about a third of a pot it just sits there. I have to shake the pot against the hopper to get it all in and seem to lose about a dozen balls, with my markers shaking all over the place and it just aint good.

Tried flexing the arms to soften them up, been trying different techniques to try and get the paint to just drop in, and have found a little improvement but cannot say it is any better than having to open and close the lid.

Can anyone offer any tips, or have I just bought a poop speed feed?

Heres a pic of the one I have.

http://cgi.ebay.co.uk/SPEEDFEED-SPEED-FEED-LOADER-HALO-Reloader-B-Pulse_W0QQitemZ310032644854QQihZ021QQcategoryZ16047QQrdZ1QQssPageNameZWD2VQQcmdZViewItem?_trksid=p1638.m122

i bought the same one and had the same problems with it so i set about it with a pair of side cutters untill it looked like this http://i190.photobucket.com/albums/z276/rich666_photos/speedfeed.jpg now it works fine . i just kept cutting a bit more off and trying it untill it worked as it should

rich

 

[A.B]

or just make one cut down the center of the 'o'

Has worked on mine fine, the fingers loosen after a while.

 

[Marcus Geezer]

i bought the same one and had the same problems with it so i set about it with a pair of side cutters untill it looked like this http://i190.photobucket.com/albums/z276/rich666_photos/speedfeed.jpg now it works fine . i just kept cutting a bit more off and trying it untill it worked as it should

rich

I've done this and it now works fine i think. Thanks for all the posts gents.