PMR Back Cap Problem

[Ion_Paintball]

Yer that defiently looks like it is unscrewed all the way... Get a fuffly and push the bolt out from the other side... abit of force should realease it... if you manage that post back up and i can explain how to get it back in

http://forums.matrixowner.com/showthread.php?t=10195

 

[Dark Stranger]

Ill try that and how do i know what to line up? i dont even know what to look for. oh and the previous owner is on holiday until monday

Oh and heres a pic of what it looks like:


As you can see it should be all the way in, but its not...

Pull harder you big nonse!

 

[Will L]

Yer that defiently looks like it is unscrewed all the way... Get a fuffly and push the bolt out from the other side... abit of force should realease it... if you manage that post back up and i can explain how to get it back in

http://forums.matrixowner.com/showthread.php?t=10195

So stick something down the front of the gun (without barrel obviously) to force it out? Ok ill try that, errm what do you mean by fluffy by the way? A barrel swap? or what?

Edit: I looked down the barrel and the inside of the bolt has a bit of old paint and a small chipping of a paint shell in it... Ahh well, if i can get this out i can clean it up though.

I dont know what a fluffy is so i tried forcing it out with the handle of a wooden spoon, but it was to thin and went inside the bolt instead of being thick enough to not go inside it but push it.

Any suggestions?

 

[Will L]

^^ Post above was edited. Please read

 

[Big Mac]

fluffy big think with fluffy bits on the end of a stick that has a rubber bit that bends in the middle - just pull it out from the back - i had this problem - i just yanked it - it came out.

 

[Gassy]

I dont know what a fluffy is so i tried forcing it out with the handle of a wooden spoon, but it was to thin and went inside the bolt instead of being thick enough to not go inside it but push it.

Any suggestions?

I think I can see a gold board coming on here

 

[Will L]

fluffy big think with fluffy bits on the end of a stick that has a rubber bit that bends in the middle - just pull it out from the back - i had this problem - i just yanked it - it came out.

I have no idea what you mean or what that is, you mean a squeegee? And ive tried pulling the back cap as hard as possible its tight, it aint moving, i can wobble it up and down which means its screwed out though (as someone has already posted)

 

[Big Mac]

http://www.slothball.com/imagepopup.php?path=product_images/Main/320_Fluffy_Swab.jpg&largexdim=350&largeydim=350&alttext=Fluffy

 

[Will L]

http://www.slothball.com/imagepopup.php?path=product_images/Main/320_Fluffy_Swab.jpg&largexdim=350&largeydim=350&alttext=Fluffy

I thought u ment swab....lol but i dont have one of those? How would that push a stiff bolt and back cap out? Have you pushed the bolt and back cap through the front before with one of these before? Did it work?

 

[rayko]

Get a wooden spoon and use the end of it or something dowel like and wrap abit of cloth around it. Then push it down the front so the the bolt assembly drops out the back.

Or if you have strong fingers you could put your finger down the breech (the bit where the balls get loaded) and see if you can push the bolt assembly out using finger pressure.

The bolt assembly is larger at the front than the back so will not push out from the other way around.

The bolt assembly is normally abit snug *which is a good thing* so giving it abit of assistance isn't a bad thing.