ive tried to change the input pressure and nothing happened. erm, when i pull the trigger it just makes a soft hissing/clicking noise.
pm7
- Thread starter das_ist
- Start date
Then you have dialled it down too far.
Read the manual.
If you are "a bit useless" as you said, then you probably shouldn't be doing it.
If you take the frame off, be careful of the eye wires, before and on putting it back together.
Did you download that manual?
Read the manual.
If you are "a bit useless" as you said, then you probably shouldn't be doing it.
If you take the frame off, be careful of the eye wires, before and on putting it back together.
Did you download that manual?
ive downloaded the manual, will try it in the morning again. im not so much 'useless' only with a proto marker because im used to my smart parts one. thanks for ur advice
did u screw both parts of the bolt together when u replaced it? when u unscrew it it comes out in 2 sections.. (if u turn it to much anyway)
both parts screw together..
i didn't the otherday cause im a prat and it leaks out the bck when they aren't
both parts screw together..
i didn't the otherday cause im a prat and it leaks out the bck when they aren't
if you are still having troubles ring ash chaplen. www.dyeprecision.com
you should be able to get his number of that website
if not give me a pm i will try to help the best i can lol. i like Proto guns
you should be able to get his number of that website
if not give me a pm i will try to help the best i can lol. i like Proto guns
Hi
Firstly, I would re-set the regs to factory setting. Using a 3/16'' allen key, wind the brass adjuster inside Hyper reg (the inline reg, which doubles as the front handle) clockwise until it stops. The wind it back out 3 1/2 full turns anti-clockwise (3x 360* and another 180*) Thats the approximate factory setting, so you should be in the right pressure range.
Next, do the same to LPR (the reg mounted into the body of the gun, above the Hyper reg) use a 3/16'' key to wind the adjuster clockwise until you feel the adjuster slow down - at which point stop turning. Be careful not to over tighten the adjuster as you can damage the reg-seat. Then turn the adjuster anti-clockwise for 4 1/2 turns (4x 360* and another 180*)
Next, air the marker up. Does it leak? Where from? Try shooting the marker a few times to see if this solves the problem.
Contact me if you have any further problems - eurotech@dyeprecision.com
Thanks
Ash
Firstly, I would re-set the regs to factory setting. Using a 3/16'' allen key, wind the brass adjuster inside Hyper reg (the inline reg, which doubles as the front handle) clockwise until it stops. The wind it back out 3 1/2 full turns anti-clockwise (3x 360* and another 180*) Thats the approximate factory setting, so you should be in the right pressure range.
Next, do the same to LPR (the reg mounted into the body of the gun, above the Hyper reg) use a 3/16'' key to wind the adjuster clockwise until you feel the adjuster slow down - at which point stop turning. Be careful not to over tighten the adjuster as you can damage the reg-seat. Then turn the adjuster anti-clockwise for 4 1/2 turns (4x 360* and another 180*)
Next, air the marker up. Does it leak? Where from? Try shooting the marker a few times to see if this solves the problem.
Contact me if you have any further problems - eurotech@dyeprecision.com
Thanks
Ash
i took it back to the shop cuz i got fed up of it lol, shop have no apparently fixed it though. so will find out soon enough. thanks for all your help anyways guys