PM5 bolt leak

[deadbox]

you say that you were 210 over the crony, you are turning your hpr out(to raise) and not in(to lower), because if you are lowering your air input there will not be enough pressure to seal the bolt.

wind your hpr all the way back in(to the right) and back it out 3-4 full turns, this should allow enough pressure thru to seal your bolt, then crony to desired fps.

 

[mctractorboy]

A guy on the team had the same problem with his PM5 not so long ago. Try turning the velocity all the way out, and then all the way back in.

It may work.

 

[ego]

Well my short term goal is just to get this sold..
So I think the best thing for it is too get this fixed up and sold.

Thanks for all your suggestions and help.

 

[lemonadeX]

I'll take it for £100 in its current form, if you're selling

-Will

 

[ego]

Well, I think that I should send it off to sloth then Ill give them your adress to send it straight to you-serviced and fixed. £200 lets say? As the virtue board inside is worth 60 its self lol

 

[lemonadeX]

Ahh right, didn't realise it had a Virtue board

£100 for the marker + stock board without sending to Sloth? Will try and get it sorted myself, cheaper for you.

Cheers,

-Will

 

[ego]

Hmmm Sounds good...
You got paypal?

 

[lemonadeX]

PMed ya Kinda the wrong section for this.