invert mini asa issue??

[WildWayz]

As Teddy said - the common issue with Minis/ any marker with no on-off, is not screwing them in enough.

 

[MeDiC]

There's something to be said about backing it out about half a turn if you're experiencing shootdown. To be fair, it happens more to people who use remote lines and turn the on/off too far down...

I had a bottle that on the reg, the pin looked like an upside down top hat. If the on/off was too far down, it choked the output of the reg, causing shootdown under sustained firing. Could be similar issues for people, the issue might not be the gat, it' could be the reg pin...

 

[WildWayz]

There's something to be said about backing it out about half a turn if you're experiencing shootdown. To be fair, it happens more to people who use remote lines and turn the on/off too far down...

I had a bottle that on the reg, the pin looked like an upside down top hat. If the on/off was too far down, it choked the output of the reg, causing shootdown under sustained firing. Could be similar issues for people, the issue might not be the gat, it' could be the reg pin...

This also makes sense - my Empire Sniper was the same - had to back out the bottle 1/4 turn otherwise it would vent air...

 

[Biscuit]

on mini`s no always bottle not screwed in fully

 

[matj]

To prevent the issue of screwing the tank all the way in etc and the pain of removing it from the mini rap4 does an external on/off meaning you can fully screw in, then allow pressure into the marker, and the same for removing it. Disconnect the air supply, dry fire the remaining and you can remove the tank nice and easy. Works wonders!

On my phone ATM but if anyone wants the link for it then let me know and ill sort it.

 

[BDswarveP]

could be your asa/reg is goosed, if its only when your ramping or firing quick, if its fine when your firing single shots then drops its usually the recharge on the reg, so it will either need replacing or servicing, and its a sod to service.