Impy WAZ board
- Thread starter L J
- Start date
Degas the reg, or at least make sure ithe on/off is off. Unscrew the retaining nut (the one on the opposite end to the spring cap, which takes a fecking big allen key.) Remove the poppet guide (brass bit with o-rings), spring retainer (another brass bit), spring and poppet (the pin thing with a cone-shaped bit.) The next 4 bits to come out comprise the seat (seat cap, white o-ring, seat base, black o-ring.) Make sure these two o-rings are spotlessly clean, and do not have any nicks or scratches. If damaged, replace. Reassemble without lubrication, except a light film on the two o-rings on the poppet guid (the last brass piece to go back in before the retaining nut.)Originally posted by QuackingPlums
errr... he's also forgotten how to "fix" that...
What do I do?
That should clear up your hot first shot
The WAS Equalizer board for the Imp also comes with an eye that is supposed to be superior to the stock Impy eye system. Apparently it reads all colors of paint, unlike some older versions of the SP eye.
The few people who have actually tried the WAS board (the Rat Factory Team) rave about it and the speed they are able to achieve. Cost will be $150 and they can be purchased from www.e-paintballoutlet.com.
The few people who have actually tried the WAS board (the Rat Factory Team) rave about it and the speed they are able to achieve. Cost will be $150 and they can be purchased from www.e-paintballoutlet.com.