Impulse

[Noza]

hey guys i took my triga frame of my impulse to clean the paint tht got in it and i had to take the trigger out and basicly im trying to put it bk to gether but the blue light wen u normaly press the triga is nt lighting up i dnt no wts rong with it pls help me thx si

 

[L J]

you may have over tightend a screw on the trigger, which pushes the micro switch past the point of activation

 

[Noza]

ok ill try undo them a bit . if it aint tht wt u think it is ?

 

[L J]

either, you havent turned it on its out of battery, or as i said u over tightened the screw, BUT you did it way to much and it snapped the micro switch

 

[Noza]

k ill chek over evrythink . thx for your help m8

 

[Noza]

no still nt working
it still cliks and evrythink jsut the trigger wnt seam to push it

 

[Noza]

hey guys jsut found the other pice of the micro switch so basicly it snaped thx alot for ur help .

 

[L J]

lol, told ya, easy to do when moving the trigger. on matrices you have to buy a whole new board if you do it, so needless to say i was careful

 

[Noza]

ye bos i no wot ur saying i mena we all lern from our mistakes . well i was gna get vision any way

 

[Shep]

just get a new micro-switch from Maplins,you want the sub-mini micro -switch cost about 80pence same dimensions as the one sp use,it is a little stronger but pm me & will tell you how to make it lighter its dead easy as internals are 1 piece not 2 piece like the sp ones