How do you adjust the trigger pull??

[rob_evanson]

Have have a Shocker with an Eclipse Blade Trigger frame but becayse I bought it second hand I don't know how to adjust the trigger pull. At the moment it's usuable but I want to make it shorter.

 

[bruce]

Rob
me again i think with the blade trigger you will need to remove the grip frame from the solinoid housing (back screw and the front reg mount), you should then be able to see 2 set screws these are the trigger stops and allow you to adjust the back and forward motion of the trigger. You may need a small amount of loctite on the screws once you are happy to stop them moving once in play.

Good luck with the new gun and welcome to the shocker family

cheers

Bruce

 

[rob_evanson]

You again!!!

Thanks Bruce, think your going to have to start chargin me for this information. But while it's still free, how do I remove the drop forward (Eclipse). Will I have to remove the four screws that hold the celeniod housing and unscreww it from there.

 

[bruce]

On the eclispe front mount there should be two small set screws, these hold the reg in place. Lossen these and the reg should drop out (you proberly will have to pull the hose free from the elbows going between the reg and the front of the body). Inside the mount will be a set screw undo this will remove the reg mount and free the front of the trigger. Then remove the back screw and the trigger should come free, just watch the wires for the battery as they go through the trigger (may be best to remove the battery first). You shouldnt have to remove the solinoid housing from the main body to do this.

adjust the trigger then put back together is basically the reverse

cheers

Bruce