help needed

[charlie11]

in my shocker, when i turn it on into vision mode with a halo on top, the first paint ball is registered and is fired properly, however the second ball is not registered and the gun acts as though is were a jam, by blinking continously.

it works fine in non-vision mode but CHOPS allot so i really want to get this working!!!!!!!!!!!

can anybody help???????? -PLEASE

charlie

 

[Hairbear89]

Tried cleaning your eye mate?

Russ

 

[charlie11]

yer lots

i have cleaned it ALLOT

is there a way u can remove the eye from the shocker body , just to clean it, cos i can only clean it so much whilst it is still in the body of the gun!!

charlie

 

[Scars]

Yes - cleaning just by ramming a fluffy down usually aint good enough. Paint will actually damage your eye after a period of time - i think its the right side with the plate/eyecover.

Take the ball detent out and then the plate thing and you should just be able to pull the eye from the body

 

[Hairbear89]

Scars is right. Take out the detent (right side), remove the eye cover and use an allen key (0.05" I think... Same one to adjust stock trigger. It's a stupid size I know) to remove the Vision screw thing and hey presto you got access to the eye.

Seeing as you're a fellow Shocker owner and all, I'll pass on this little gem of a website.

http://www.zdspb.com/tech/index.html

Russ

 

[charlie11]

aaaahhhh

fantastic........... cheers guys i shall have a go at that this afternoon and post up again to see if it has worked!!

charlie

 

[Scars]

What colour paint you using - shocker use reflection eyes so wont see all shades of paint

 

[charlie11]

im using red paint and another section of orange

they have been fine in the passed!!

charlie

 

[Hairbear89]

Red and orange should be fine. It's mainly the darker colours you have to watch out.
Give your eye a good clean and keep us updated

Russ

 

[charlie11]

eyes cleaned

i have officially cleaned my eye sooo wel its unbeleivable!!! lol
i went 2 homebase and got the pathetically small allen key and got it out, found sum paint on it
cleaned it off
STILL DUSNT WRK!!!!
i regassed it and fired off 1round thinkin wooo it wrks
then tried 2 fire another and it wont let
me but it still lets me in non- vision
could it be a link between the vision mode and the solenoid board????

please help guys ur doing gr8 so far!!!!

charlie