evo 2 y board question
- Thread starter kris
- Start date
Y-Board Installation in to a Push Button Style eVLution 2
"Upgrade to Y-Board"
Take out the old board. Connect your motor (BE#131157-000, DZ#3219) 4 hole plug to the Y-Board (BE#131123-000, DZ#4514) making sure that the red wire is on the same side as the "+" on the board.
Your wiring harness (BE#130523-000, DZ#2601) will need to be modified. Cut and/or remove the yellow wire that goes from the clip to the 3 hole plug. DO NOT cut the yellow wire on the battery clip. If you do not cut the yellow wire it will short out the batteries causing them to heat up, damage your EV2 housing and possibly damage the Y-Board. If you cut the wire on the battery clip you will get nothing because you just broke the power circuit to the board.
Courtesy of DropZone Paintball
Note VL advertise it as eVlution II with x-board strangely enough
"Upgrade to Y-Board"
Take out the old board. Connect your motor (BE#131157-000, DZ#3219) 4 hole plug to the Y-Board (BE#131123-000, DZ#4514) making sure that the red wire is on the same side as the "+" on the board.
Your wiring harness (BE#130523-000, DZ#2601) will need to be modified. Cut and/or remove the yellow wire that goes from the clip to the 3 hole plug. DO NOT cut the yellow wire on the battery clip. If you do not cut the yellow wire it will short out the batteries causing them to heat up, damage your EV2 housing and possibly damage the Y-Board. If you cut the wire on the battery clip you will get nothing because you just broke the power circuit to the board.
Courtesy of DropZone Paintball
Note VL advertise it as eVlution II with x-board strangely enough
I traded it with my revy and additional 15 Euro at DMA2003 because my feedneck had serious cracks - on my way to get it exhanged the lid on the revy exploded when I wanted to clean out some paint on the inside...Originally posted by Paul_collier
What??? you guys bought them??...... on purpose??
Didn't really want a new Revy after that - took my chances with the Zeppelin...
Pinky