egos do for sure and star frame eteks id guess.
seems the stock LED board doesnt.
Etek 2 Low First Shot Velocity Problem
- Thread starter jmelech
- Start date
seems the stock LED board doesnt.
just thought id post this here rather than via PM
unfortunately I could not advise you on how to fix the velocity problem as it never happened to me. The gun was working perfectly when I sold it to you, i never experienced any first ball drop off.
in regards to the PM you sent asking me asking for a refund or to pay for the repairs. I feel I am not responsible for a gun I sold to you a month ago as I dont know what you have done with it while you have had it.
If this problem had occurred the first time you had used the gun then I would have expected you to contact me straight away, in which case I would of happily given you a refund or paid for the repairs.
unfortunately I could not advise you on how to fix the velocity problem as it never happened to me. The gun was working perfectly when I sold it to you, i never experienced any first ball drop off.
in regards to the PM you sent asking me asking for a refund or to pay for the repairs. I feel I am not responsible for a gun I sold to you a month ago as I dont know what you have done with it while you have had it.
If this problem had occurred the first time you had used the gun then I would have expected you to contact me straight away, in which case I would of happily given you a refund or paid for the repairs.
My recommendation.
Strip and rebuild all parts / at least clean and regrease/oil as appropriate
Replace the rammer orings
Replace the battery.
Set the dwell to whatever stock setting is.
Strip and rebuild all parts / at least clean and regrease/oil as appropriate
Replace the rammer orings
Replace the battery.
Set the dwell to whatever stock setting is.
sponge bob this was the first time I have used the marker and as such posted this thread to try and fix the problem without getting you involved, this has not been possible and so I messaged you regarding the problem and the steps I have already taken to attempt to fix this
stan I live in Lancaster but can travel if needed, why?
stan I live in Lancaster but can travel if needed, why?
You haven't done the dreaded..grip screw into the solenoid trick have you...:tsk:
Set it all back to factory then try it...
Set it all back to factory then try it...
From the manual...
sympton Low Velocity First Shot
Possible cause DWELL parameter is too low to overcome
stiction on Solenoid and / or Rammer O-rings.
solution Increase DWELL parameter.
Page 40.
there are silver marks from screws but none have caused a hole in the solenoid, there is no gas leaking at all, the marks are quite substantial and I have only removed the grip frame once to put in a fresh battery as suggested above as I had no reason to before