ego7 velocity query
- Thread starter Rider
- Start date
meant lubed as well.....
ryan: settings are at stock, LPR about 1/8th turn past flush, will try taking it out. do you mean flush with then indent in the housing or with the tip of the housing - i always had assumed the indent. didn't think about the oops being too far in - will look at that too.
will run through all these things (some of them again) and see how it goes.
replace reg piston
ive had that problem before.
FWIW flush with the indent is how I ran my guns, FTW
ive had that problem before.
FWIW flush with the indent is how I ran my guns, FTW
I'm not sure what has been recommended for EGO7, but on the 05/06 etc, LPR was two turns in from flush, then set the dwell accordingly.
Has it ever shot over that? Meaning, is it new to you?
If it has got considerably colder where you are, remember that teh dwell may need to be increased.
I think Stock, is 16 on an 07.
If its an early gun, with a body number between 20002 and 205??, then it could also be the solenoid.
Has it ever shot over that? Meaning, is it new to you?
If it has got considerably colder where you are, remember that teh dwell may need to be increased.
I think Stock, is 16 on an 07.
If its an early gun, with a body number between 20002 and 205??, then it could also be the solenoid.
You could also try replacing the reg piston...not the o-ring on it, the piston, because the black seal at the back goes and then its fooked....