Ego TT filter

[crumpler]

Ok 1se again im confused about seting the debounce on the ego, in manual it says the higher the TT band the lass able the ego will be to bounce and the lower the TT Tol the less able the ego will be to bounce, but my question is this:

Cant i just put TT Band all the way up and TT tol sll the way down? will that do any thing to the gun? Why cant i do that?

Edit: i just found a beter thing telling me how to do it but if any one can give me some tips that would be good

 

[Lovetone]

set trigger how you want it first in terms of pull and magnet
set tt band to 75% tt tol to 10%

work the tol down to around 6% and see where / if it bounces.
alternatively whack the band up nearer 80% and repeat.

once your set you can adjust the trigger tension if required but dont mess with the pull and see if it bounces

thats how i did it anyways


if you have band 100% and tol 1% you wont bounce but it will slow the gun down

 

[crumpler]

ok MR lovetone, one more question, i have my TT tol on 4% and TT band on 80%. I have a tiny little bit off bounce, what would you say best to do lower TT tol or turn up TT band??

P.S. any one can answer this if they have one?

 

[Skeet]

TT Band...You need to watch teh rising bar graphic as you pull teh trigger...it needs to be reach across the full range of teh TT Band, from start to finish...go by the two side bars at top and bottom...teh more of teh pull it can see, teh better.

Raise TT Tol, upwards a bit till teh bounce goes, without slowing teh gun down...dont go over 10% if you can help it.

If not, re adjust teh trigger.

 

[crumpler]

ok i didnt quite understand much off that, but what i thing your saying is when the trigger is fully pulled it needs to be above the top marker and when it is depressed it needs to be below that. Well thats bit seems fine to me and i have a fair bit of trigger pull (at the end of the trigger its just under 5MM)(FBM trigger)

But wont riseing the TT tol make the gun bounce more?

 

[Skeet]

Sorry, lower it...

 

[crumpler]

ok i will have a little play later, are there any other setings that could make a difference in bounce?

Also is there a reason why i cant set it over 15bps?

 

[Skeet]

You cant set it over 15, because you cant.
Only in Semi2 will it go over 15 if your fast enough

 

[Lovetone]

wrong skeet

Semi 1 is uncapped (or just "semi" on older software)
Semi 2 or "CFOA" on older boards is capped at 15
all other ramp modes regardless are capped at 15

so crumpler, you cant set the ROF over 15 for the capped modes
semi one is uncapped



as for the trigger set up once you have set the pull etc then adjust the settings, not the other way round

or just see someone who can do it for you in person, or get planet to set it up for you

 

[crumpler]

ok, well i havnt gone about geting software updated, but you no how much it cost? I may just send it off to Planet and get the trigger and the software all sorted out