ego chopping/smashing paint

[Polly]

right guys could do with some help here. Went trainin yesterday and chopped/smashed paint ALL day. Wasnt too bad when i was one balling but after a couple of shots in a string the rest would break.
paint barrel match was good, paint wasnt too brittle, battery was new, eyes working fine, chrono'd at approx 266 and even reset board to factory settings to see if that would help but alas it was not to be.
need to get this sorted for the weekend so any help is greatly appreciated.


P.S. since last use (before yesterday) i have fitted a 15* frm if that makes any difference. and i also screwed the lpr screw out a bit to see if that helped but just went outside and it broke paint again.

 

[YourMUM]

Cheque that the rammer is screwed in all the way, if its loose the bolt will NOT come all the way back and will chop like a chopping chopper from the planet chop

 

[JAYDB]

was the paint stored in a cold place over night maybe? that could solve your problem... keep the paint warm

 

[Revolt]

change your detents...

 

[PKNUTZ]

fresh batterys in the hopper?

 

[Robin Hood]

Change your underwear, works every time.

 

[Polly]

will try some new detents, any other ideas?

 

[deadbox]

What mode (red/green)are you using on your hopper, do you have the RF chip installed in your gun?

If you use the green mode(RF mode) and don't have a chip installed, it will only pulse every 5 seconds, this will allow gaps in your ball stack when you rip on it and cause chops. Use the Red mode and it will pulse every 0.5 second preventing gaps forming and causing chops.

 

[Polly]

using red mode mate i dont have rf chip. hopper shouldnt be the problem as the eyes were always on.

 

[baffy]

fresh batterys in the hopper?

.