Egg Hoppers...

[NBR]

Does anyone know when the Egg will be out in various different colours.... ie Blue/ Smoke/ Red/ Green etc...?

As its the only thing stopping me from getting an IR3 and making WDP just that little bit richer (not that they don't deserve it of cource!)!

Cheers

 

[Beaker]

Just die a clear one any colour you like

 

[P8ntbllr99]

Just die a clear one any colour you like

and how do u do that.

and nbr jus get a halo then if you want different colors

 

[Beaker]

p8ntball99

in the US - RIT dye
In the UK - Dylon (I think it's called)

Do a search on pbnation, many peeps have died hoppers etc

 

[MORPHUS]

egg hoppers

hi
sorry to hijack alittle
any 1 know of where i can purchase a sleve/collar for my egg2 evo as it doesent fit my highrise on my evo cocker and before any1 says it no i dont want to use electrical tape.......
thanks
paul

 

[sykesg]

Morphus,

see the roughneck link below

 

[Mark]

Not your fault but it would be nice if the site worked, sure it loads but the store section when you try and click on any upgrade parts (whatever marker btw) comes up page not found.

 

[Ben Frain]

Originally posted by nbr
Does anyone know when the Egg will be out in various different colours.... ie Blue/ Smoke/ Red/ Green etc...?

As its the only thing stopping me from getting an IR3 and making WDP just that little bit richer (not that they don't deserve it of cource!)!

Cheers

Whichever one you get you will have to sand the F*** out of the feedneck to get it to fit.

I also cut about 15mm of the feed tube to lower the profile (few tense minutes with the junior hack saw!).

However, that done, they work great on the IR3. Mine has a low rise, hence all the shortening of feed tube, which if you go for a base or C+C model you probably won't need to do.

 

[Gyroscope]

If you need to make 'em smaller, you sand 'em. If you need to make 'em bigger, you put two part epoxy on em, then let it dry, then you sand.

NW Paintball makes great feed necks (and drops). Their necks have two o-rings inside to keep things secure.

 

[Gyroscope]

If you want to cut an Eggo II neck evenly, go get a copper tubing cutter from a hardware store (they have the two part epoxy, too).
Put an old barrel (Autococker and Spyder type both work) up the neck to keep it rigid. Then, tighten the tube cutter on the neck of the Eggo II and start spinning it around the neck, tightening slowly as you go.

Perfect cut in no time.