Dye Hopper Insert

[Dazzer13]

Hi

http://www.a-teampaintball.co.uk/mall/ATeamPaintball/products/product-711029.stm

Fits inside the feed neck of your hopper and expands it. Therefore the hopper will fit nice and tightly in the feed of the gun and will not require tape to hold it place.

that is wot the site said but i dont get it, if the insert went inside the hopper neck then it would get in the way of the infara red and the ball descent , so i thought it went on the outside but then i wouldn't fit on the low rise, so wot do u do with it.

First i thouaght it might of been used to re-inforce the hopper neck, stoping it from breaking , or to stop the light so the infara red can work better on clear revys

wot do u do with this.

cheers

daz

 

[Parksy]

See my reply on your classifieds post mate

Dave

 

[Dazzer13]

BUt wouldn't it get in the way of balls and the infara red ???


DAz

 

[Parksy]

No mate it doesn't go up that far to interfere with the beam.

And if you look at it its beveled outwards so there is no where for a ball to actually catch onto

Trust me, use it if your hoppers too slack in your marker, but apart from that there no use at all

Dave

 

[Dazzer13]

If the neck goes over the low rise wouldn't it make a lip which the balls would bounce on or something

and the same with the hopper insert

cheers

daz

 

[PaRaDOx]

WTF are you on it goes int he hopper neck then it all sits IN the low/high rise nothing sits over the high rise at all.

 

[Dazzer13]

lol ok i am going to sit under a stone and hide for a few days cos i am a DIP stick

lol

cheers paradox


daz

 

[Parksy]

Even I'm confused now

 

[joe bob]

I think you all know how I feel now