dwell on an ion
- Thread starter Ali
- Start date
To set the dwell:
1. Bottom out the dwell
2. Set your input pressure to about 120 psi
3. Increase the dwell until the marker cycles properly at +/- 10 fps consistency
4. Increase your input pressure up to desired fps
5. Increase the dwell up by 1 until velocity stays consistent. If consistency is already good. reduce the dwell down by 1 until it becomes inconsistent, then bring back up 2.
1. Bottom out the dwell
2. Set your input pressure to about 120 psi
3. Increase the dwell until the marker cycles properly at +/- 10 fps consistency
4. Increase your input pressure up to desired fps
5. Increase the dwell up by 1 until velocity stays consistent. If consistency is already good. reduce the dwell down by 1 until it becomes inconsistent, then bring back up 2.
