DM trigger pin removal

[Lump]

hammer on table, but must try on stone in daylight

 

[Cliff-In2Deep]

stock trigger to heavy and wont pass a bounce test

is it not the spring behind the trigger causing it to bounce had this problem before cut down a spring from a pen worked for me that's if the spring is there at all...

 

[G.Ash]

hammer on table, but must try on stone in daylight

is it the stock handle?
if so have you removed the trigger set pins it also needs to be tapped out from the left side of the handle,
i have a ul on mine if you want to buy my stock one you can

 

[Skeet]

Yeah...I think the pins are handed, so one side will be bigger than the other.

If all else fails, cut the pin off and bang it back the other way.

 

[Cliff-In2Deep]

Yeah...I think the pins are handed, so one side will be bigger than the other.

If all else fails, cut the pin off and bang it back the other way.

yes they are tapered on one side with a spline shaft normally..

 

[Beaker]

I've used bicycle chain breakers to get trigger pins out before, but no idea if they can/will work on a DM5 frame.

 

[Lump]

dont it today at work bigger hammer concrete floor

 

[Dark Stranger]

dont it today at work bigger hammer concrete floor

Clap, Clap, Clap