B2 hopper issues

[fathead]

Hi guys I have a B2 hopper and all of sudden it's just stopped workin, I've taken it apart, cleaned it, changed the battery, an just no reaction when ever my marker goes off, I've tried it empty an still nothing, hope someone can help or just let me no if these have this type of issues with them, or just tell me to stop bein a tight a**e an buy a new one lol
Cheers

 

[Bolter]

Sounds very much like you have pinched or even severed the battery wire when putting it back together? Take the shell off and check the wiring for a crimped bit, or the wire is in 2 bits

If not that, check the battery wire is plugged into the board properly.

 

[fathead]

will check that an lets see howi get on, thanks

 

[Liam92]

is the led coming on when you are attempting to power it on? if so you know the problem lies between the board and the motor and obviously if the led isn't coming on, the problem is between the battery and the board.

 

[fathead]

stripped it down completly all wires and connecters all good, led comes on just get no movement when noise ges off near it, guess it looks like a new hopper is on the way, any ideas?

 

[Bolter]

stripped it down completly all wires and connecters all good, led comes on just get no movement when noise ges off near it, guess it looks like a new hopper is on the way, any ideas?

Oh right, the LED comes on, I thought it just didn't work! Well its could be that the sound sensitivity is too low, or even the belt has come off the motor. Try upping the sound settings

 

[NitroBall]

sounds like the mic's gone.
not uncomon for these.

 

[fathead]

How do u change the sound settings? An if the mics gone is there any point in gettin it replaced? Or just except it an get a new hopper?

 

[NitroBall]

How do u change the sound settings? An if the mics gone is there any point in gettin it replaced? Or just except it an get a new hopper?

Im not sure if you can change the sound settings on the B2, its been a long time since ive used one.

If all connections/battery is good, then either tap the back plate or blow into the mic when you have the back plate off. If nothing is happening, then possibly the mic.

 

[NitroBall]

Another note !

Have you checked the motor just to make sure it hasnt burnt out.