Autococker part !

[NitroBall]

I am at present restoring an Eblade that has been sat in someones kit bag for years.

The part i am looking for is a very small plastic seal (similar to an oring, but is a very small flat piece of plastic) which sits on a screw when securing a hose from the QEV to the top of the cocking noid manifold.

This might not be a specific cocker part, but cannot seem to find any online stores listing these.

If anyone has any or point me in the right direction ?

Thanks.

 

[famsuks3]

Any pics try an engineering workshop????

 

[baudsenseless]

use a bit of plastic from a "takeaway chinky" pot cut to size!

 

[renie]

NitroBall Like this , if so Drop me your addy mate ill stick it in the post for you (10p not included )

 

[NitroBall]

use a bit of plastic from a "takeaway chinky" pot cut to size!

I am going to try this first, if no luck, will post up a pic.

rennie, thanks for the offer, but unfortunately it is not a rubber oring.

 

[renie]

I am going to try this first, if no luck, will post up a pic.

rennie, thanks for the offer, but unfortunately it is not a rubber oring.

its flat came off a 10/32 fitting i had

 

[renie]

think its rubber though lol

 

[renie]

NitroBall also i could make you one if you dont have any luck

 

[NitroBall]

its flat came off a 10/32 fitting i had

10/32 sounds a bit big, not sure what size but deffo smaller.
Will let you know later rennie

 

[baudsenseless]

to be honest i never use them! renie - its white plastic, it does help to stop overtightening the qev/barb etc you can use a rubber one, but the rubber tends to push out, plastic stays in place more