Hi all,
Selling my one off custom cocker.
I bought this a box of parts and have built it from there.
The body has been shortened. From the rear of both chambers. The front has not been touched so you still get the large air volume.
A turtle half block kit is installed. You will never be hit in the goggle again by the back block or need a beaver tail.
Dye Hyper reg installed.
EGO 06 frame installed.
Zero B board installed.
MQ2 valve installed. This £150 solenoid valve replaces nearly the entire internals of the bottom chamber. So you no longer need, rex dialer, hammer, spring, sear, sear trip solenoid, etc. It is controlled by the same board in place of the old grip frame mounted sear trip solenoid.
Due to the removal of the material due to the installation of the half block and the removal of superfluous internals due to the install of the MQ2 valve the marker is now much lighter than stock.
I bought this as a project as I was brought up on custom cockers and has had 5 in my time. With me being DYE sponsored the actual gun time this would see would be negligible so I am looking to sell it on.
£350 via paypal owed or you add 4%.
Item will be sent out via rec del.
Regards
Ed
Apologies for the poor pics I took them before I had to jump on the train so it was dark and I needed to use a flash.
View attachment 15194
View attachment 15195
Selling my one off custom cocker.
I bought this a box of parts and have built it from there.
The body has been shortened. From the rear of both chambers. The front has not been touched so you still get the large air volume.
A turtle half block kit is installed. You will never be hit in the goggle again by the back block or need a beaver tail.
Dye Hyper reg installed.
EGO 06 frame installed.
Zero B board installed.
MQ2 valve installed. This £150 solenoid valve replaces nearly the entire internals of the bottom chamber. So you no longer need, rex dialer, hammer, spring, sear, sear trip solenoid, etc. It is controlled by the same board in place of the old grip frame mounted sear trip solenoid.
Due to the removal of the material due to the installation of the half block and the removal of superfluous internals due to the install of the MQ2 valve the marker is now much lighter than stock.
I bought this as a project as I was brought up on custom cockers and has had 5 in my time. With me being DYE sponsored the actual gun time this would see would be negligible so I am looking to sell it on.
£350 via paypal owed or you add 4%.
Item will be sent out via rec del.
Regards
Ed
Apologies for the poor pics I took them before I had to jump on the train so it was dark and I needed to use a flash.
View attachment 15194
View attachment 15195
