Can somebody give me the specs for the positioning for the detent bearing on an Autococker frame,thanks...
Cocker detent..
- Thread starter tiffer
- Start date
E blade manual can be found here
http://www.planeteclipse.com/folders/Downloads/Manuals/EbladeVol1.pdf
has the drilling guide for the eye
Tiffer,
Just measure my Eclipse bodied pump. The detent is 45mm back from barrel face, as in where barrel screws up to, and 38mm up from the the bottom where grip frame mounts to. I don't think it needs to be 100% accurate to work ok. The thread size is quoted 3/8 - 24 UNF. If the detent hangs into breech too far it'll chew bolt to bits. This can be prevented by trapping an o-ring under the detent.
http://buy1.snapon.com/catalog/item.asp?item_ID=9810&group_ID=1166
Another useful page..
http://haveblue.org/tech/autococker/index.shtml
BTW - did you play at Holmbush (pumps) today?
Just measure my Eclipse bodied pump. The detent is 45mm back from barrel face, as in where barrel screws up to, and 38mm up from the the bottom where grip frame mounts to. I don't think it needs to be 100% accurate to work ok. The thread size is quoted 3/8 - 24 UNF. If the detent hangs into breech too far it'll chew bolt to bits. This can be prevented by trapping an o-ring under the detent.
http://buy1.snapon.com/catalog/item.asp?item_ID=9810&group_ID=1166
Another useful page..
http://haveblue.org/tech/autococker/index.shtml
BTW - did you play at Holmbush (pumps) today?