ion banjo or qev
- Thread starter blackplasma
- Start date
mactoshdog, any advance on £8?
not sure which banjo i need i had 3 on the board when i recieved it 2 plastic, pushfit, allen key ones and a smaller, silver, bolt like, spanner fit one with a barb, the smller one was on the rear hose and the plastic ones were at the front and middle.
silver one leaks from arround the hose/barb bit.
was going to get a plastic one hopefully to go at the back or a qev to go in the middle and move the current one to the back?
am i doing the right thing here?
ive built this ion from scratch and never really had one apart before!
not sure which banjo i need i had 3 on the board when i recieved it 2 plastic, pushfit, allen key ones and a smaller, silver, bolt like, spanner fit one with a barb, the smller one was on the rear hose and the plastic ones were at the front and middle.
silver one leaks from arround the hose/barb bit.
was going to get a plastic one hopefully to go at the back or a qev to go in the middle and move the current one to the back?
am i doing the right thing here?
ive built this ion from scratch and never really had one apart before!
QEV goes on the middle (breech) position. The plastic banjos go at the front (air input from reg) and rear (firing can) hose connections.
but ifd you dont have a qev what banjo should go in the middle?
is it normal to have the small metal one in the middle? if so maybe i should try swapping the middle for the back one, so ive got plastic each end and metal in the middle?
front and rear are normally 5/32" bajos.
the middle is noramlly a 1/8" banjo - this is the one replaced by a QEV.
the middle is noramlly a 1/8" banjo - this is the one replaced by a QEV.
id just go for the clippard one mate.
its easly better than a 360 or banjo and not a bad price either
(i use one)
its easly better than a 360 or banjo and not a bad price either
(i use one)