Welcome To P8ntballer.com
The Home Of European Paintball
Sign Up & Join In

ego 8 troubles

glenn

glenn

Platinum Member
Dec 2, 2008
458
20
38
Stockton-on-tees
well i got home after playing yesterday cleaned it all up

when i gassed it this morning there is a small leak from around around the qev solenoid area, im not sure if its not just the tubing but they are on pretty tight and i dont wanna go just ripping them off

any ideas?
 
Impulse raider

Impulse raider

RAMPAGE/SNATCH
Jun 4, 2008
1,925
118
98
HAMPSHIRE
glenn said:
well i got home after playing yesterday cleaned it all up

when i gassed it this morning there is a small leak from around around the qev solenoid area, im not sure if its not just the tubing but they are on pretty tight and i dont wanna go just ripping them off

any ideas?
Click to expand...
1, Check the qev Block screws aren't loose .
2, Check that you haven't over tightened the grip screw and bent one of the qev barbs.
3, Run your fingers around the pipework and see if you feel any air.
 
glenn

glenn

Platinum Member
Dec 2, 2008
458
20
38
Stockton-on-tees
ok just checked

and the qev screws aint loose and the barbs ain bent but the leak appears to be coming from pipe on the barb (rather than the qev cap with barb)
 
glenn

glenn

Platinum Member
Dec 2, 2008
458
20
38
Stockton-on-tees
i want to swap the pipes over to see if the fault move which will confirm i just need a new pipe but can someone confirm u just pull these off as they on pretty tight
 
Impulse raider

Impulse raider

RAMPAGE/SNATCH
Jun 4, 2008
1,925
118
98
HAMPSHIRE
pipe

glenn said:
i want to swap the pipes over to see if the fault move which will confirm i just need a new pipe but can someone confirm u just pull these off as they on pretty tight
Click to expand...

If you are going to replace the pipe alot easier to actually cut it off .

Cut the new pipe to the same length and replace .
 
You must log in or register to reply here.
Top Bottom