My Evo-X E2

[Skeet]

i put a brand new battery in it and it had been doing it for a while btw what is the SON time?

Sear
On
Time

Its the time that the sear solenoid, is activated for. If it is too short, then the sear will go down then back up again, before the sear lug has gone far enough not to get caught, so it gets caught. May take two or three pulls of the trigger before it fires.

This can also happen with a correct SON time, if the gun is gunked up, battery is low or sear lug is wound down too far.

 

[Chinn]

Thanks Skeet for the help but i have found out what the problem was from DB from Belsales he said it just needed a service very happy and pleased with Belsales

 

[Skeet]

Thanks Skeet for the help but i have found out what the problem was from DB from Belsales he said it just needed a service very happy and pleased with Belsales

Needing a service isn't a problem mate, it's a solution to a problem.

He didn't say exactly why it was doing that? I hate it when they do that, not necessarily Belsales, but companies in general.

Mind you, I guess it is your fault for not asking exactly what the problem and it's cause was

 

[Chinn]

well he said he cleaned the frame out and know its fine thanks Skeet

 

[Skeet]

well he said he cleaned the frame out and know its fine thanks Skeet

I see, might have been gunk around the sear etc then, which will make it slow and not release the hammer properly then.

DB is the man. Don't see him much on here any more...

 

[no-infernomark]

yes DB is the man, sent him a rare aim frame and sent back a miracle!!!