Barrell backs or an insert kit?

[Codiak]

whats the opinion out there, need to decide on where to spend on bore sizes.
do i just go out and buy a freak back and use inserts or buy the varios bore backs from the likes of dye / eclipse etc?

 

[lemonadeX]

I'd recommend the Lucky Un1tec barrels - Get a single back which has the same thread as your marker, then the fronts fit into this so you don't need to worry about the bore of the back. Then just get a range of fronts (perhaps go for a drainpipe .695, a medium .689 or .690 etc).

 

[pyroLX]

I recently got my deadlywind fibur, havent tested it a lot yet, but it is SO nice so far. Its carbon fiber, swabable (the only CF that is swabable), and takes freak inserts. Noticed a good accuracy improvement, but I have to spend some more time with it.

 

[Lump]

its down to how much you want to spend, a second hand freak set will set you back £40 with all the inserts you will need. dye backs your looking at £80+

a good buy atm is 3cp back and one front for £50 with all the sizes you need

 

[Codiak]

its down to how much you want to spend, a second hand freak set will set you back £40 with all the inserts you will need. dye backs your looking at £80+

a good buy atm is 3cp back and one front for £50 with all the sizes you need

where from sir?

 

[spangley_special]

to be honest, i'd just get a large-ish back (around .692/.693) and then a pretty much average bore (.688/.689)

that'll have you covered in most situations, at least it does me

 

[Lump]

these cp ones are mint i love them

http://www.p8ntballer-forums.com/vb/showthread.php?t=98069

 

[Codiak]

to be honest, i'd just get a large-ish back (around .692/.693) and then a pretty much average bore (.688/.689)

that'll have you covered in most situations, at least it does me

the eclipse back i have right now is 693 having bother prising it from the front tho, the seller told me the font it type 1 threaded.

 

[Lump]

the thread on planet barrels is backwards try undoing it by grabing it if you were to tighten it

 

[TinFish]

to be honest, i'd just get a large-ish back (around .692/.693) and then a pretty much average bore (.688/.689)

that'll have you covered in most situations, at least it does me

yep, i agree, I only use the standard .693 on my ego...find it does the job with most paint.