Fitting asa.....
- Thread starter Tayler D
- Start date
You wont need any locktite or sealant to fit it matey
Just do them screws up and your away
-ChEf
p.s what make is it & what gat is it going on?
You wont need any locktite or sealant to fit it matey
Just do them screws up and your away
-ChEf
p.s what make is it & what gat is it going on?
Custom Products PRO mini on/off ASA @ £35.00, and yes.. going on an Ion
one of these?
http://store.customproducts.us/index.cfm?fuseaction=catalog.prodInfo&productID=176&categoryID=3
If it is, I had one of these on my old matrix. Piece of cake to fit. Really small allen key screw on the side if I remember rightly. Undo that, slide onto rail, tighten up. Rail screws onto grip frame either inside or through two larger allen bolts. (cant remember exactly which
).Either way, its easy stuff. So long as you can use a allen key, your all good.
If your needing to replace or fit new elbows then thats a different story. You will need either locktite or tape.
Hope that helps in some way
-ChEf
Both do the same job.
To be honest i've only managed to source loctite from the net as of yet
Have a good read of the stickies regarding the various types of locktite and there uses
-ChEf
Personally I would use PTFE tape, but thats just me, but if ur gonna use glue go to your local DIY shop as I found it the best place for stocking it and u can get different strengths, so check which one your getting. As topchef recommended check the stickies