Ego 07 leaking

[Dskize]

i would strip and clean the vert reg and lpr (follow the manual) ...small possibility that the pressure is creeping up and causing a noid problem.

pretty easy to do if you do the above (FTM) ,if its a noid issue there's nowt you can do till planet open anyhoo..

 

[Sid Sidgwick]

Exactly the same problem here Joey, also a Disruption, stripped all of mine, including reg, LPR, rammer ect after a leak from the grip frame. Tryng it again today so ill see how it works now. Wa it cold when yours was doing it as mine has been fine for months but started when the temp dropped to below 4 degrees (im assuming here that there it could posibly be shrinkage of tubing/seals ect due to cold)

 

[Skeet]

Slightly...slightly, tighten the minifold screws that hold it to the Noid.
My mates ones were loose and caused a leak around the noid that came and went.

 

[Sid Sidgwick]

Cheers Skeet ill give that a go

 

[jitsuwarrior]

Cheers Skeet ill give that a go

Sid remind me to give you some Snoop Leak detection fluid mate, it will help you identify the leak and it is completely none corrosive. It may cut down your fault finding time to minutes instead of hours.

 

[Skeet]

Sid remind me to give you some Snoop Leak detection fluid mate, it will help you identify the leak and it is completely none corrosive. It may cut down your fault finding time to minutes instead of hours.

Fairy Liquid...some water...small straw...sorted.

Or spit...

Or Vegetable Oil...non Corrosive...

 

[Sid Sidgwick]

Cheers guys, traced the prob down to the solanoid so looks like a job for planet, seens as I have no spare bits here. Damn looks like im scuppered on the 28th now

 

[Skeet]

Where on the solenoid?

If its the o-rings twix noid and minifold, flip them over.

 

[Sid Sidgwick]

Need some smaller scredrivers to seperate the solanoid but it seems to be the front part of the noid, has a constant leak which when pressure is applied to the noid casing gets worse

 

[Sid Sidgwick]

right got the noid apart Skeet and put it all back together, ill let you know what happens