barrel size
- Thread starter e-whore
- Start date
Im with Gassy on this one.
I have never bothered with bore sizes and have better things to do in the morning than spend an hour sizing barrels up.
I am pretty sure that not EVERY single ball you use all day is going to be the same size, so why bother?
Stick on a .693 or .695 and have no problems at all like I dont
Nige
optimally there should be 3 points of contact tween, ball and barrel
however, its too much hassle, balls are never a consistent size.
and my barrel kit has 4 massive backs, so i just use one closest to what im shooting, i dont find a perfect fit, and usually i cba to change so i just end up using the biggest one.
overboring ftw
however, its too much hassle, balls are never a consistent size.
and my barrel kit has 4 massive backs, so i just use one closest to what im shooting, i dont find a perfect fit, and usually i cba to change so i just end up using the biggest one.
overboring ftw
I only bother with boring if its with reballs, they don't break and are fecking small sub 0.684. There is a noticable difference between Large 0.693+ bore with small bore paint through it.
Are you being completely honest Nige???I have never found that accuracy has been bad from having too BIG a barrel size. But obviously a too smaller barrell size will just mince your balls
I use the blowing technique just to be safe....... It dosn't take an hour more like less than a minute!
Now Im confused???
I dont have any barrels smaller than .693 and have only used the standard shaft on my EGO7 last season and nickys 8 the other day. My Nexus has a .695
Do you know something I dont?
Nige
Lol!No mate I don't....... Just thought that you might have used something a bit smaller
I used to use a 10" front but always a big back
Its not the length, its the girth!!!
Nige
