Angel a4 fly leak

[SAMUEL.D.RYAN]

Ok, so this angel has been running fine so far. I just put a new board in (un1chip) and after about 30 dry fires, i heard a hiss, so i turned the air off, undid the breech and carefully re gassed to work out where the air was leaking from.
It's coming from some part of the RAM but i don't have any orings to replace the current ones with, and i'd rather not buy some until i know that's the problem.
If it makes any difference, i was using a PMI bottle with a crossfire LP reg into a SP on/off to the stock LPR. I have little air left in my bottle so it's probably not firing 100%.

Any help would be greatly appreciated!
Thanks

 

[WingNut]

LoveJuice is your friend....

Take a look in the manual at what it says about adding oil......

 

[Tom Allen]

it may be just that your air is so low, get the bottle gassed up and check again.

 

[SAMUEL.D.RYAN]

Yeah, i hope it is the air, i've ran three or four drops of trinity (LiPS' equivalent) through the macroline every time i've used it...

cheers guys, when i find some air to run it with, i'll post back!

 

[WingNut]

Yeah, i hope it is the air, i've ran three or four drops of trinity (LiPS' equivalent) through the macroline every time i've used it...

Be careful not to 'over oil' it.

Sure I read somewhere that to much oil was just as bad as none.

 

[SAMUEL.D.RYAN]

oh really? I'll make sure i only put it in every 3 cases then...

thing is, i don't play as often as i'd like with my angel, and when i do play, i don't shoot much. Meh, i'll see what air does to it...

 

[Tom Allen]

i think the norm for oiling is two drops after a good days play. Over oiling can be a real problem, i've replaced a solenoid when i was teching at the pa due to this on an ir3.