EGO7 with new board and the Pulse
- Thread starter PaulC
- Start date
Of course I am biassed but they rip.
There were some early issues on 07's but these are ok with the new board BUT you have to have the correct settings on the board and then they are absolutely fine.
There were some early issues on 07's but these are ok with the new board BUT you have to have the correct settings on the board and then they are absolutely fine.
Care to elaborate om that mate?
Mate is receiving an 07 shortly and we want to put an RF in it.
Can you not use a normal harness (as you would in an 05) have they changed teh solenoid plug in teh 07.
What is teh issue and the solution?
Cheers
The issue was only on 07's and was to do with signal levels. With the initial 07's (around last November) we had a stack up of tolerances between our RF circuitry and the new EGO boards - so there was some hit & miss of getting them working consistently. We also found that the battery charge stae played a role.
All you need to do is make sure you have the 3.10 software or above and set it up right.
If you are buying your 07 from Planet then they have the link leads for sale and if you ask nicely I am sure they will set the settings for you.
If not then we are at every Millennium and we can take a look then for you. Or I will try & help you via email.
Well, assuming the RF chip still tee's into the solenoid, then I have a couple of looms for it, assuming they haven't changed the plugs.
What are the settings that need to be adjusted, and too what mate?
Thanks for your help.
What are the settings that need to be adjusted, and too what mate?
Thanks for your help.
Are you saying more sttings must be changed other than turning on/off the RF signal in the v3.1 hadware settings??